Mitsubishi Electric FX5-DP-M, Руководство пользователя

Страница: 52 / 176

50
7 PARAMETER SETTINGS
7.3 PROFIBUS Module Setting
7.3
PROFIBUS Module Setting
Start PROFIBUS Configuration Tool and configure the PROFIBUS module settings. (

Page 51 PROFIBUS Configuration
Tool)
[Navigation window]  [Parameter]  [Module Information]  [FX5-DP-M]  [PROFIBUS Module Setting]
7.4
Update of PROFIBUS Labels
This function creates and updates the structures used for global labels and module function blocks by enabling the refresh
settings.
[Navigation window]  [Parameter]  [Module Information]  [FX5-DP-M]  [PROFIBUS Module Settings] 
[PROFIBUS Configurator Tasks]  [Setup Tasks]  [Update PROFIBUS Label]
Precautions
After the "Module Parameter" screen is displayed, make sure to update the PROFIBUS labels.
7.5
Writing Parameters
Check the boxes in the "Module Parameter and the "PROFIBUS Module Setting" on the "Online Data Operation" window of
the GX Works3 before writing.
[Online]

[Write to PLC]
The parameters have different write destinations.
For the writing parameters to the CPU module or the SD memory card of the CPU module, refer to the following.
 GX Works3 Operating Manual
The written parameters are enabled when resetting the CPU module or powering off and on the system.
The set parameters using PROFIBUS Configuration Tool can be written with the GX Works3, but cannot be
read.
Checked item Written parameters Write destination
Module Parameter Refresh Setting CPU module or the SD memory card of the CPU module
If the parameters are written to both the CPU module and the SD memory card, the operation is
performed according to the memory card parameter setting of the CPU module.
PROFIBUS Module Setting PROFIBUS communications
parameters