EN-13
Setting up your projector (continued)
Adjusting the position of the
projected image
To adjust the position of the projected image on the
screen, use the LENS SHIFT dial.
1. Rotate the LENS SHIFT dial inside the top cover of
the projector to adjust the image position.
• Rotating the dial clockwise (or counterclockwise
for a ceiling-mount projector) moves the image
up.
• Rotating the dial counterclockwise (or clockwise
for a ceiling-mount projector) moves the image
down.
• Be careful not to be caught in the opening in the
lens while the lens is moving.
• While the lens shift is working, the screen may
fl icker.
• Projected images may become distorted, have
decreased resolution, or have shadows at their
corners if they are positioned close to the top or
bottom.
When projected images are
distorted to a trapezoid
When AUTO KEYSTONE in the INSTALLATION menu
is set to ON, this projector automatically corrects
vertical keystone distortion. For fi ne adjustment, press
the KEYSTONE button on the projector or the remote
control to display Keystone, and adjust the image by
pressing the
,
button (or +, - button on the remote
control).
KEYSTONE
0
KEYSTONE menu
You can correct the distortion vertically focusing on
the screen center.
In the following cases:
Press the
or - button.
Press the
or + button.
Important:
• The automatic keystone adjustment may not
be carried out correctly because of the ambient
temperature and the installation conditions of the
projector and the screen. In such cases, correct the
keystone manually.
• When the projector is projecting images where
acceleration is present, such as in a vehicle and
aircraft, the automatic keystone adjustment may
not function correctly. In such a case, set AUTO
KEYSTONE in the INSTALLATION menu to OFF and
correct the keystone manually.
• When the KEYSTONE-mode adjustment is carried
out, the adjustment value is indicated. Note that
this value doesn’t mean a projection angle.
• When the KEYSTONE-mode adjustment takes
effect, the resolution decreases. In addition, stripes
may appear or straight lines may bend in images
with complicated patterns. They are not due to
product malfunctions.
• When the KEYSTONE-mode adjustment is
performed, the displayed image may be distorted.
• Noise may appear on the screen during the
KEYSTONE-mode adjustment because of the type
of the video signal being projected and the setting
values of the KEYSTONE-mode adjustment. In
such cases, set the KEYSTONE-mode adjustment
values in the range where the image is displayed
without noise.
• When the KEYSTONE-mode adjustment is
performed, the menu display is distorted. To relieve
such symptom, set the MENU POSITION to center.
Intelligent glare sensor:
To prevent discomfort feeling to the eyes caused
by seeing the illuminating light source through the
lens, the intelligent glare sensor detects a person
who stands in front of the projector and mutes the
projected images automatically.
• The intelligent glare sensor detects an object
placed in front of the lens and shuts off the screen.
Therefore, do not place any object within 50 cm
from the front of the sensor.
• The sensor may detect a transparent board.
• To cancel muting temporarily, press the POWER
button on the projector or the ON button on the
remote control.
