Mitsubishi Electric CITY MULTI PUMY-P112VKM6, Руководство по обслуживанию

Страница: 133 / 142

OCH790 _133
F1 F2 F3 F4
Settings menu
Service menu:
Function setting
Lossnay
Cursor
2. Set the function.
• Press the F1 or F2 button to move the cursor to one of the following: M-NET address, function setting number, or
setting value.
• Press the F3 or F4 button to change the settings to the desired settings.
• Once the settings have been completed, press the [ ] button.
A screen will appear indicating that the settings information is being sent.
• To check the current settings of a given unit, enter the setting for its M-NET address and function setting number,
select Conf for the Function, and press the [ ] button.
A screen will appear indicating that the settings are being searched for.
When the search is done, the current settings will appear.
When the settings information has been sent, a screen will appear indicating its completion.
• To make additional settings, press the [ ] button to return to the screen shown in the above step. Set the function
numbers for other indoor units by following the same steps.
Notes:
• Refer to the indoor unit Installation Manual for information about the factory settings of indoor units, function setting
numbers, and setting values.
• Be sure to write down the settings for all functions if any of the initial settings has been changed after the completion
of installation work.
Function setting
Cursor Address
Select:
M-NET address
Function No.
32
Data
Function
2
Set /Conf
3
Function setting
M-NET address
Function No.
32
Data
2
Setting completed
3
Return:
Function setting
M-NET address
Function No.
32
Data 2
Sending data
3
13-5-2. PAR-SL97A-E
Functions can be selected with the wireless remote controller. Function selection using wireless remote controller is avail-
able only for refrigerant system with wireless function. Refrigerant address cannot be specified by the wireless remote
controller.
Operating instructions
1. Press the
CHECK
button twice continuously. →
CHECK
appears and ˝00˝ blinks.
• Press the TEMP button once to set the address number to ˝50˝.
• Direct the wireless remote controller toward the receiver of the indoor unit and press the
h
button.
2. Enter the unit number.
• Press the TEMP button to enter the unit number.
• Direct the wireless remote controller toward the receiver of the indoor unit and press the
min
button.
By setting the unit number with the
min
button, the specified indoor unit starts performing fan operation.
Detect which unit is assigned to which number using this function. If unit number is set to AL, all the indoor units in
the same refrigerant system start performing fan operation simultaneously.
Notes:
• If a unit number that cannot be recognized by the unit is entered, 3 beeps of 0.4 seconds will be emitted.
Reenter the unit number.
• If the signal was not received by the sensor, no beep or a ˝double beep˝ will be emitted. Reenter the unit number.
3. Select a mode.
• Press the TEMP button to set a mode.
• Direct the wireless remote controller toward the sensor of the indoor unit and press the
h
button.
→ The sensor-operation indicator will blink and beeps will be emitted to indicate the current setting number.
Setting number: 1 = 1 beep (1 second)
2 = 2 beeps (1 second each)
3 = 3 beeps (1 second each)
Notes:
• If a mode number that cannot be recognized by the unit is entered, 3 beeps of 0.4 seconds will be emitted.
Reenter the mode number.
• If the signal was not received by the sensor, no beep or a ˝double beep˝ will be emitted. Reenter the mode number.
4. Select the setting number.