Mita DP-1400, Инструкция по эксплуатации

Страница: 100 / 134

5.5 Indicators and Messages
5-10
Error Messages
Table 5.3 Error Messages
Message Corrective Action
Memory overflow
Press CONTINUE
The total amount of data received by the printer exceeds the printer's internal mem-
ory. Try adding more memory (expansion RAM). Press the
CONTINUE
key to resume
printing. You can abandon printing by the
CANCEL
key.
Print overrun
Press CONTINUE The data transferred to the printer was too complex to print on a page. Press the
CONTINUE
key to resume printing. (The page may break in some pages.)
You can abandon printing by the
CANCEL
key.
Note:
After this message has been displayed, Page protect mode will be On. To
maintain optimum use of memory during printing, display
>Page protect
from the control panel, and re-select
Auto
.
See the last page in this manual.
KPDL Error
Press CONTINUE
Current print processing cannot continue.
To print out a error report, display
> Print KPDL errs
from the mode select
menu, and select
On
.
Press the
CONTINUE
key to resume printing. You can abandon printing by the
CANCEL
key.
RAM DISK error ##
Press CONTINUE
Check the error code displayed in the place of
##
and refer to the appropriate descrip-
tion below.
01
: Abnormal format. Try turning the power off and on again.
02 : RAM DISK mode is Off . Turn RAM DISK mode On .
03
: Cannot write to the disk system because it is write protected. Remove the write
protection.
04
: No disk space. Clean up files.
05 : Specified file not on disk.
06
: No memory for use by disk system. Expand printer memory.
10
: Cannot format disk because host data is spooled there. Format the disk after
Ready
is displayed.
98
: Unable to read files during the sorting (file does not exist, or corrupted).
MEMORY CARD err
Insert again
The memory card is accidentally removed from the printer's memory card slot during
reading. If you continue reading the memory card, insert the same memory card into
the slot again. The printer again reads it from the beginning of the data.
Note: We recommend that you follow the reading procedure from the begin-
ning to ensure correct reading of the memory card.
Insert the same
MEMORY CARD
You have inserted the wrong memory card when the Insert again message was
displayed. Remove the wrong memory card from the printer's memory card slot and
insert the correct memory card. The printer again reads it from the beginning of the
data.
Format error
MEMORY CARD
This message appears when the printer is in the ready state and the memory card is
not formatted, and therefore cannot be read or written. Follow the procedure on Sec-
tion
2.6 . to format the card.
Warning battery
MEMORY CARD
This message appears when the printer is in the ready state and the battery in the
memory card is low. You can still enter the memory card mode, but the battery should
be changed as soon as possible.
Battery error
MEMORY CARD
This message appears when the printer is in the ready state and the battery in the
memory card is dead, or there is no battery at all. It is not possible to use the memory
card mode until you insert a good battery in the card.