Mita DP-1400, Инструкция по эксплуатации, Страница: 98 / 134

5.5 Indicators and Messages
5-8
Maintenance Messages
Table 5.2 Maintenance Messages
Message Corrective Action
Top cover
Open
Open the top cover, then close tightly.
Side cover
Open
Open the side cover, then close tightly.
Paper feed unit
Open Open the paper feed unit, then close tightly.
Face-down tray
paper full
The face-down tray has become full (approx. 250 pages). You must remove all printed
pages from the face-down tray. When the printer senses that the face-down tray is
empty again, it will continues printing into the face-down tray (Model DP-1800 only).
Add paper
(paper source)
(paper size)/(paper type)
*(paper size) and (paper
type) are displayed flashing
alternately.
The paper has run out. Supply paper according to the paper source displayed (paper
cassette, MP tray, or optional paper feeder).
Set paper
Press CONTINUE Add a sheet of paper to the MP tray, and press the
CONTINUE
key.
Paper jam Open the top cover or the paper feed unit and correct the paper jam (or paper mis-feed-
ing in the cassette). See Section
5.6 .
Warning
Low memory
The printer's internal memory is running low due to the number of fonts and macros
downloaded. Print a status page to see how much user memory is left, and try deleting
unnecessary fonts and macros. See the PRESCRIBE 2e DELF and DELM commands
explanation in the programming manual (CD-ROM).
Option interface
Error
A failure has occurred with the option interface.
Check the option interface installed on the printer.
Toner low
Clean printer
Replace the toner container using a new toner kit. See Section 4.1 .
Replace Toner
Clean printer
Replace the toner container using a new toner kit. The printer does not operate when
this message is displayed. See section
4.1 .
Clean printer
Press CONTINUE
Please clean the inside of the printer. See Section 4.2 .
This message will be displayed when replacing the toner container after the message
Replace Toner Clean printer
has been displayed. After cleaning the
inside of the printer, press the
CONTINUE
key and the printer will be ready for printing.
Replace Waste-
toner bottle
Replace the old waste toner bottle with the new one which is included in the BT-2000
toner kit. The message will also be shown if the waste toner bottle has become full. The
waste toner bottle should be replaced when the message display eventually shows
Toner low Clean printer
. See Section 4.1 .
Missing Waste-
toner bottle
Install the waste toner bottle. See Section 1.4 . The printer does not operate when this
message is displayed.