miDoor: revision 0.01
Installation and Reference
© Mission Machines, Inc., 2012
15
Locate the original garage door opener’s control button and remove it from the wall and the
attached wires. With the button and wires removed attach the miDoor device to the wall using
the supplied Velcro.
To attach miDoor to the wall peel off the protective cover of the adhesive strip from the Velcro
and push the strip against the wall. It is recommend to leave the Velcro attached to the miDoor
device and simply attach the Velcro to the wall by positioning the miDoor device to the correct
location and pressing it (adhesive side of the Velcro) to the wall.
Please be sure to position the miDoor device such that the existing wires from the garage door
opener can reach the miDoor device.
Once miDoor is attached make sure
¼
inch of conductive wire is showing from each wire that
was removed from the original garage door push button and push the bare wire into the right-
most openings of the 7-pin terminal block. (These are the openings labeled as “
2
Garage Door
Opener” in Figure 3 (Bottom of miDoor).)
It may be necessary to cut the tips of the wires that attached to the original garage door push
button and re-strip them if they are too frayed or damaged to push into the terminal block.
After the miDoor device is attached to the wall and the control wires are attached to the miDoor
device the next step is to install the garage door open and close magnetic proximity sensor
(included).
