16
– English
English
6.4
– INSTALLING AND CONNECTING
KEYPAD mod. MK
The control keypad is a wall-mounted device used for control of the
automation via a Bus connection. Up to 4 keypads can be connected in a
single system and the device can be programmed to operate in two
modes: Traditional mode (each key performs a specifically assigned func-
tion–
factory set
) and safety mode (to activate a manoeuvre, a secret key
sequence must be entered, as set by the user).
The keypad is backlit for poorly lit conditions.
To install and connect the keypad proceed as follows:
01.
Fig. 32:
Remove the keypad cover by pushing down one side as shown in
the figure.
02.
Fig. 33:
Using a screwdriver, open and detach the base of the keypad.
03.
Fig. 34:
a)
Drill a hole on the pre-cut section on the base for routing the con-
nection cables.
b)
Fix the keypad base to the wall with the relative screws, routing
the cables through the prepared hole.
04.
Fig. 35:
a)
Connect the cable wires to the respective terminals.
b)
Insert the cable connector in the male connector at the rear of the
keypad.
05.
Fig. 36:
Refit the cover, ensuring that the serrated section engages with that
of the keypad base.
06.
Fig. 37:
Fix the keypad cover to the base by means of the screw supplied.
Lastly refit the screw cover cap as shown in the figure.
Note
– To program the keypads in the system, refer to STEP
9.3
.
34
37
36
35
33
32
