MIOX RIO Zuni 1, Инструкция по установке, эксплуатации и обслуживанию

Страница: 15 / 46

MIOX RIO Zuni™ Operators Manual
P/N: 102-00094-I Page 15
INSTALLATION AND STARTUP
The RIO Zuni OSG has been factory tested and must be properly installed per the
instructions in this manual.
SAFETY PRECAUTIONS AND WARNINGS
Ensure that the facility and the installation are in conformance with all codes
and standards.
Please refer to the MIOX Hydrogen Safety White Paper or your local authority
having jurisdiction for more information.
A liquid barrier system is mandatory. Ensure that all hydrogen vent lines
slope towards the oxidant tank.
Ensure that no valves, drop legs, or P-traps are in the hydrogen vent lines.
Do NOT cross connect vent lines.
Ensure that brine and oxidant tanks are labeled properly.
Disconnect power before working on the system. Do not reconnect the power
to the rear panel until installation is complete.
All MIOX systems require a good earth ground. A neutral is not a substitute
for a proper earth ground. Electrical wiring to all MIOX systems should be
performed by a certified electrician.
In the Box
1) RIO Zuni OSG
2) RIO Zuni Quickstart Guide
3) RIO Zuni Installation, Operation, and Maintenance Manual
4) Documentation Kit
5) Power Cord
6) Standard Parts Kit
a. Level Switch Assembly (comes pre-installed if an Oxidant Storage Tank was
ordered from MIOX)
b. Tubing and hose clamps
7) Integrated Brine Tank (if ordered)
8) Oxidant Storage Tank (if ordered)
9) Inline Pressure Reducer Kit
10) Hydrogen Vent Kit (comes partially pre-installed if an Oxidant Storage Tank was
ordered from MIOX)
What you need
To install the MIOX RIO Zuni, you need:
Safety