MINN KOTA Ultrex 1368800, Руководство пользователя

Страница: 38 / 61

ADJUSTING THE DEPTH OF THE MOTOR
a. With the motor in the deployed position, firmly
grasp the motor Shaft above the Steering
Module.
b. Locate the Depth Collar on the Shaft. Loosen
the Depth Collar Knob, while holding the Shaft in
place, until the Shaft slides freely.
1
c. Raise or lower the motor to the desired depth.
d. Tighten the Depth Collar Knob on the Depth
Collar to secure the motor in place.
Once the boat is on the water, it may be necessary to adjust the lower unit up or down to achieve an optimum depth for motor
performance. When setting the depth of the motor, be sure the top of the motor is submerged at least 12” below the surface of
the water to avoid churning or agitation of surface water.
Adjusting the Depth of the Motor
NOTE: Please be sure the top of the motor is
submerged at least 12” below the surface of the
water to avoid churning or agitation of surface water.
Shaft
Shaft Shaft
Steering Module
Steering Module Steering Module
Propeller
Motor
Depth
Collar
Knob
Depth
Collar
Knob
Depth
Collar
Knob
Depth Collar
Depth
Collar
Knob
12" Minimum Depth
2
c. With the motor in the deployed position, firmly
grasp the motor Shaft above the Steering
Module.
d. Locate the Depth Collar on the Shaft. Loosen
the Depth Collar Knob, while holding the Shaft in
place, until the Shaft slides freely.
e. Raise or lower the motor to the desired depth.
f. Tighten the Depth Collar Knob on the Depth
Collar to secure the motor in place.
g. Stow the motor again and confirm that the Lower
Unit is resting on the Mount Ramps in the Motor
Rest Area. If it is not resting in the recommended
location, re-deploy the motor and re-adjust until it
sits where recommended when stowed.
NOTE: Once the Lower Unit is resting in the proper
position on the Mount Ramps, always secure it in
place with the Hold-Down Strap.
WARNING
The Control Head will create a pinch point if the Depth Collar
Knob is loosened and the Control Head slides to the top of the
Depth Collar. Grasp the Shaft and prevent it from sliding all the
way down to prevent the pinch point.
1b
1d