INDEXING THE MOTOR
9
Wrap Drum Cover
Wires
Steering
Module
Screws
8
Cable Anchor
Wrap Drum Cover
Steering Motor
Connection Wire
k. Reconfirm that the Steering Cables are tight
and then carefully thread the Steering Motor
Connection Wire through the top of the Wrap
Drum Cover. The male plug comes from the Cable
Anchor through the opening at the bottom of the
Wrap Drum Cover. The wire with the female plug
that runs out the top of the Cable Gear should
also be pulled through the opening at the bottom
of the Wrap Drum Cover.
l. Place the Wrap Drum Cover down on top of the
Cable Anchor and align the screw holes on it with
the screw holes on the Cable Anchor. Make sure
the Wrap Drum Cover is nested securely on top of
the Steering Module and that the wires pass out
the top of the Wrap Drum Housing. Secure the
Wrap Drum Housing in place with the two screws
that were originally removed using a #1 Phillips
screwdriver. Tighten to 6 in-lbs.
CAUTION
Take care not to pinch the Steering Motor Connection
Wire while the Wrap Drum is set into place.
10
Steering Motor
Connection Plug
m. Reconnect the Steering Motor Connection Plug
and push it into the Wrap Drum Cover.
n. Orientate the wires connecting the Steering
Motor Connection Plug as noted so that the wires
do not touch moving parts.
o. Replace the Connector Cover.
CAUTION
Wires and plug must not touch moving parts. Wires may
be damaged if caught in moving parts.
Wrap Drum Cover
