ROUTING UNIVERSAL SONAR & -PILOT LINK CABLES
d. Grasp the opposite ends of the extension cables
for the Universal Sonar, and i-Pilot Link, if
equipped.
e. Start at the top of the Coil Cord, where it is
attached to the Control Head and pass the
cable(s) through the center of the Coil Cord
towards the Pedal Control Sleeve Assembly.
f. Use a tie wrap cable to secure the cables to the
top of the Coil Cord, leaving only enough slack to
let the cables hang comfortably.
g. Below the Coil Cord, measure the extension
cable(s) 8 to 10 inches in length and make a loop
with them.
h. Loosely secure the end of the loop to the Cable
Jacket that runs from the Pedal Control Sleeve
Assembly to the Foot Pedal.
3
4
5
3e
3f
Control Head
Universal
Sonar
Universal
Sonar
Tie Wrap Cable
Placement
i-Pilot Link
i-Pilot Link
Coil
Cord
Coil
Cord
Secured Cable
Placement
i. Locate the Depth Collar, and while grasping the
Shaft, loosen the Depth Collar Knob.
j. Continue to grasp the Motor Shaft and raise
the Control Head to test if the loop in the
extension cables provides adequate slack for full
functionality of the motor.
k. Rotate the motor shaft to be sure the wire
routing does not interfere with moving parts at
different depth collar settings.
l. Carefully stow and deploy the motor to test for
adequate slack.
m. Adjust slack if needed and if adequate, secure the
tie wrap cable that was placed around the Cable
Jacket.
4g
4h
Coil
Cord
Loop
Pedal Control
Sleeve Assembly
Depth Collar
Pedal Control
Sleeve Assembly
Cable Jacket
Cable Jacket
Depth
Collar
Knob
Motor Shaft
Control Head
CAUTION
Do not secure the Extension Cables to the bottom of
the Coil Cord. Improperly securing the Extension Cables
may cause damage to the product and void your product
warranty.
i
