PLACING THE BOW-MOUNT STABILIZER
a. Place the motor in the stowed position.
b. Un-thread the Aluminum Rod
(Item #13)
from the
Stabilizer Bracket
(Item #12)
by removing the Top
Bumper
(Item #11)
and unscrewing the bracket.
Also remove the Bottom Bumper
(Item #15)
.
Keep the Jam Nut
(Item #14)
in place.
1
Placing the Bow-Mount Stabilizer
Top Bumper
Stabilizer
Bracket
Jam Nut
Aluminum Rod
Bottom Bumper
ITEM(S) NEEDED
#11 x 1
#12 x 1
#13 x 1
#14 x 1
#15 x 1
NOTE:
The Bow-Mount Stabilizer Bracket can be
installed on the left or right side of the Steering Module.
When mounting the bracket onto the Ultrex, the two
Nylock Nuts (Item #16) are discarded because the bolts
are secured directly into the Steering Module.
The Bow-Mount Stabilizer Bracket is used to stabilize the Steering Module and reduce bouncing when the motor is stowed
and transported. Attention to detail is needed for successful installation of the stabilizer. We recommend to have the stabilizer
bracket installed by a qualified marine installer.
12
Steering Motor
Connection Plug
CAUTION
Adjusting the Aluminum Rod too tightly removes the end play needed for proper latch pin engagement and doing so could
prevent the mount from fully latching in the stowed position. Improper latching may cause damage. If installed correctly, the
tip of the Aluminum Rod should lift off of the boat deck about 1/4” without the mount unlatching. Cutting the Aluminum Rod
too short will cause inadequate support of the mount. Lack of mount support may cause damage.
CAUTION
Wires and plug must not touch moving parts. Wires may
be damaged if caught in moving parts.
#16 x 2
r. Reconnect the Steering Motor Connection Plug
and push it into the Wrap Drum Cover.
s. Orientate the wires connecting the Steering
Motor Connection Plug as noted so that the wires
do not touch moving parts.
t. Replace the Connector Cover.
