INDEXING THE MOTOR
5
g. Once the Cable Tension Screw is loosened, prying
the Wrap Drum straight up off of the Cable Gear
using a heavy flat-blade screwdriver, until the
Wrap Drum is free of the Cable Gear.
CAUTION
Care must be taken so that the Steering Cables remain
on the Wrap Drum when it is disengaged from the Cable
Gear. It is important that the Steering Cables follow the
grooves on the Wrap Drum so that they do not become
intertwined or pop off. Be sure that the electric wire is
not damaged as the Wrap Drum is lifted.
Cable Gear
Flat
Screwdriver
Steering
Cables
Wrap Drum
Cable Anchor
3
CAUTION
Be careful to not damage the Steering Motor Connection
Plug ends.
e. Remove the two screws that hold the Wrap Drum
Cover in place with a #1 Phillips Screwdriver.
Once removed, lift the Wrap Drum Cover away
from the Steering Module.
Steering
Module
Wrap Drum
Cover
Steering Motor
Connection Plug
Steering Motor
Connection Plug
Screws
4
f. The Cable Tension Screw that holds tension on
the Steering Cables is located under the base of
the Toe End of the Foot Pedal. This screw can be
loosened just enough so that the Steering Cables
can be pinched together between the Cable Anchor
and Wrap Drum. Use a #3 Phillips screwdriver to
loosen this screw. Turning the screw approximately
8 turns counterclockwise should provide enough
slack in the cables to adjust. Keep track of the
number of turns the screw is unscrewed so it can
be re-tightened accordingly later.
NOTE:
The cables are fed through the Cable Anchor
and wound around the Wrap Drum. The right cable
is the shorter cable and begins winding on the Wrap
drum from the top down. The left cable is the longer
cable and begins winding on the Wrap drum from the
bottom up.
CAUTION
Over loosening the Cable Tension Screw may cause the
cables to disengage from the Wrap Drum.
Cable Tension
Screw
Toe End of
Foot Pedal
