REMOVAL OF THE STEERING MODULE
a. With the gas spring disconnected, place the
motor in the deployed position.
b. Remove the 5/16" Allen Screw with a 1/4" Allen
Wrench. The 5/16" Allen Screw is located on the
opposite end of the mount from the hinge that
opens and closes when the mount is stowed and
deployed.
c. Once the Allen Screw and Lock Washer are
removed, lift the Steering Module straight up
until it is free from the mount.
1
2
1
WARNING
Moving parts can cut or crush. The gas assist lift
mechanism is under pressure. Disconnect gas spring
before removing motor from mount. Do not engage the
Pull Grip and Cable until gas spring is disconnected.
a. To reassemble the Steering Module, start with
the mount in the deployed position.
b. Align the Keyways on the inside of the Steering
Module with the End Links on the mount. Do this
by positioning the Steering Module above the
End Links on the mount.
c. Lower the Steering Module straight down until
seated.
B. REMOVE MOTOR FROM MOUNT
C. REASSEMBLE THE STEERING MODULE
Allen Screw with Lock Washer
End Links
Keyways
d. Once the screws are removed, the pin and
spacers can be removed from the Upper Cylinder.
e. Now it is safe to move the motor into the
deployed position.
2
Gas Spring Cylinder
Outer Arm
Outer Arm
