REMOVAL OF THE STEERING MODULE
a. In order to remove the Steering Module, the
Gas Spring needs to be disconnected. Place the
motor in the stowed position.
b. To disconnect the Gas Spring, locate the Upper
Cylinder Pin. Two Phillips Screws hold the Upper
Cylinder for the Gas Spring in place. Using two #3
Phillips screwdrivers, hold the screw at one end
of the Upper Cylinder Pin in place.
c. Remove the screw at the opposite end of the pin
with the other #3 Phillips screwdriver.
1
Removal of the Steering Module
WARNING
The gas assist lift mechanism in this unit is under high
spring pressure when the motor is in the deployed
position. Do not remove the Steering Module assembly
from the mount without disconnecting one end of the gas
spring. Failure to do this can create a condition where
accidental pulling of the Pull Grip and Cable may cause
the mount to spring open rapidly, striking anyone or
anything in the direct path.
WARNING
Moving parts can cut or crush. The gas assist lift
mechanism is under pressure. Disconnect gas spring
before removing motor from mount. Do not engage the
Pull Grip and Cable until gas spring is disconnected.
A. DISCONNECT THE GAS SPRING
Phillips Screw
Phillips Screw
Phillips Screw
Spacers
Spacer
Spacer
Gas Spring
Cylinder
Gas Spring
Cylinder
Outer Arm
Outer Arm
Outer Arm
Outer Arm
NOTE:
Use a #3 Philips screwdriver to remove the
screws. They have a pre-applied thread locker. Not using
the recommended tool can cause damage and prevent
them from being removed.
Upper
Cylinder Pin
