Now turn carefully the wire
and look that you do not make
scratches on the fuselage. A
bit of masking tape can help to
avoid this.
Now, holding the front end in,
press the rear end into the
slot. Take care that the hole
in the fuselage and in the rear
skid holder of the mechanic
are corresponding. Press the
skid as long in as the radius
is reached. If you look from
inside the skid should end
exactly at the inner edge of the
skid holder. If not then move it
as long if this is the case.
Then tighten the rear grub
screws using Loctite 243 with
a long 2mm hex driver. Take
care that the landing bow wire
is not coming out of the block.
The batteries could be dama-
ged from it.
