The screws are easier to
mount if you look before atta-
ching the screws into the hole
to what direction the thread is
going about. The rubber blocks
are elastic so during mount it
is not always guaranteed that
the thread is also in the center
of the bush. After attaching all
screws it will be centered.
Mount the screws using Loctite
on the thread.
Two plastic blocks must be
mounted on the elevator servo
with four hex screw D84 and
washers 002 (use no Loctite!).
Note that the block D270 on
the cable side is 2 mm higher
than the block D299 on the
other side.
