Pull the tailbelt thru the boom
(a wire with a bended end
works best). Remove with a
fi le or sanspaper the black
anodizing a little bit at the front
end so that there is an electric
contact between frame and
boom. Insert the boom with the
clamp into the frame.
Fuselage mount
Attach the screws for the tail-
boom clamps with Loctite 243.
Tighten the lower right screws
fi rst when you have tightened
the long screw D93 in the
boom clamps.
Now press the boom careful in
the fuselage tail. Look that the
foam on the boom will newhe-
re be damaged. This foam is
necessary to eliminate noisy
resonance vibrations from
the fuselage. Note that the fi t
between fuselage and mecha-
nic was factory tested and so
you should use no force for the
mount.
