Mini COUNTRYMAN PLUG-IN HYBRID, Руководство пользователя

Страница: 265 / 344

Display (CID). Settings for the pre-condi-
tioning and charging process are also ac-
cepted for planned departure times.
Setting the charging mode
Via the Central Information Display (CID):
1. "My MINI"
2. "Plan charging/climate control"
3. Select the desired setting:
– "Charge immediately": the charging
process starts as soon as the charg-
ing cable is connected.
– "Charge for departure time": If a de-
parture time is set, a time frame for
charging can be set, e.g., to charge
using a cheap electricity rate.
Setting a time frame for charging
Via the Central Information Display (CID):
1. "My MINI"
2. "Plan charging/climate control"
3. "Set low cost time slot"
4. Set start for charging.
5. Set end for charging.
The vehicle can also start the charging proc-
ess before the selected time frame begins or
end it after the selected time frame finishes.
The status update of the charging process is
adjusted so the vehicle can be as fully
charged as possible and, if applicable, its cli-
mate adjusted by the departure time.
Set the charge current for charging
via a Mode 2 charging cable
Depending on the electrical mains, the vehi-
cle must be charged with a different charge
current strength, refer to page 258 .
Via the Central Information Display (CID):
1. "My MINI"
2. "Plan charging/climate control"
3. "Settings charging current"
4. "Level 1 (120V)"
Settings are stored. When you change
charging locations you also might need to
change the setting for charging.
Set the charge current strength at third-
party domestic socket outlets to the lowest
level.
Set the charge current for charging
via a Mode 3 charging cable
Depending on the electrical mains, the vehi-
cle must be charged with a different charge
current strength, refer to page 259 .
When charging with an Mode 3 charging
cable, the charging process can be com-
pleted faster at an AC charging station.
Via the Central Information Display (CID):
1. "My MINI"
2. "Plan charging/climate control"
3. "Settings charging current"
4. "Level 2 (208-240V)"
Settings are stored. When you change
charging locations you also might need to
change the setting for charging.
The charge current can only be changed
when charging with a fast charging cable
(mode 3) with single-phase charging cur-
rent.
Stopping the charging process
The charging process can be stopped at any
time by removing the charging cable and
continued at a later time by connecting the
charging cable. For example, this enables
other consumers to use the electrical con-
nection in the meantime or prevents simul-
Seite 265
Charging the vehicle MOBILITY
265
Online Edition for Part no. 01405A54208 - II/22