Briefly pressing the
(No) key or
will delete the flashing limit value; on the
right-hand side, a flashing cursor indicates that a new entry can be made.
Initialization is possible on both scales.
1.
After selecting a checking application, briefly press the
key.
Weight
The previous lower limit is also displayed in the "PW" display with the unit that
was activated before pressing the
key.
This weight value is also displayed flashing in the "Count" display. The yellow LED
illuminates.
[SET.LOW] is shown in the "Weight" display.
2.
Use the keypad or a scanner to enter a numerical weight value, which is then
displayed in the "Count" display.
The entered value does not flash. Only the actual cursor position (which is
designated by an underscore) flashes. The entry starts on the right-hand side.
The "Count" display shows the same unit as in the "Weight" display.
3.
Confirm the entry by briefly pressing the
(Yes) key.
[SET.HI] is shown in the "Weight" display.
Weight
The previous upper limit is also displayed in the "PW" display with the unit that
was activated before pressing the
key.
This weight value is also displayed flashing in the "Count" display. The red LED
illuminates.
Briefly pressing the
(Back) key will discard the entry; the limit is not
changed.
4. Use the keypad or a scanner to enter a numerical weight value, which is then
displayed in the "Count" display.
The entered value does not flash. Only the actual cursor position (which is
designated by an underscore) flashes.
5.
Confirm the entry by briefly pressing the
(Yes) key or discard by pressing the
key.
If the limit conditions are correct, the checking application is initialized.
Compact scale Puro® LargeCount
5 Operating
EN-24
Minebea Intec
