Mindray BeneHeart D2, Руководство оператора

Страница: 191 / 208

Defibrillator/Monitor Operator’s Manual F - 3
For BF applied parts
◆
100μA in Normal Condition
◆
500μA in Single Fault Condition
F.7 Mains on Applied Part Leakage
The Mains on Applied Part test applies a test voltage, which is 110% of the mains voltage, through a limiting
resistance, to selected applied part terminals. Current measurements are then taken between the selected
applied part and earth. Measurements are taken with the test voltage (110% of mains) to applied parts in the
normal and reverse polarity conditions
The following outlet conditions apply when performing the Mains on Applied Part test.
■
Normal Polarity
■
Reversed Polarity
LIMITS
■
For CF applied parts: 50 μA
■ For BF applied parts: 5000 μA
F.8 Patient Auxiliary Current
Patient Auxiliary currents are measured between any selected Applied Part connector and the remaining
Applied Part connector s. All measurements may have a true RMS only response.
The following outlet conditions apply when performing the Patient Auxiliary Current test.
■ normal polarity (Normal Condition)
■ reverse polarity (Normal Condition)
■ normal polarity with open neutral (Single Fault Condition)
■ reverse polarity with open neutral (Single Fault Condition)
■ normal polarity with open earth (Single Fault Condition)
■ reverse polarity with open earth (Single Fault Condition)
LIMITS
For CF applied parts,
◆
10μA in Normal Condition
◆
50μA in Single Fault Condition
For BF applied parts,
◆
100μA in Normal Condition
◆
500μA in Single Fault Condition
NOTE
•
Make sure the safety analyzer is authorized comply with requirement of IEC61010-1.
•
Follow the instructions of the analyzer manufacturer.