MIMAKI tx300p, Руководство по эксплуатации, Страница: 47 / 130

2-17
2
2
2
5
6
Chapter 2 Basic Operation
Setting the torque limiter
The feeding and take-up device direct-connection unit is
also included when you purchase the product. If you do
not use feeding/take-up tension bar, replace direct-
connection unit with torque limiter.
The feeding and take-up torque can be adjusted with the
torque limiter.
(The torque limiter is set to "Medium" at delivery.)
If the tension is too strong to use a thin sheet of media,
lower the take-up torque with the torque limiter.
Clockwise turn :
Increases torque (a heavy and thicker media such as
tarpaulin or the like)
Counterclockwise turn :
Decreases torque (For light media)
• When the torque limiter is adjusted too weak ;
The media can not be taken up firmly.
• When the torque limiter is adjusted too strong ;
The slack may occur depending on the media and
cause influence on the image quality.
• When using the tension bar,
adjust the torque limiter at about
75 to 100% of the maximum
torque.
When adjusting the torque
limiter, use the torque
adjustment handle supplied.
• There are the following two methods for taking up
the media on printer:
(1) Only use the take-up device to take up the
media
(2) Use the tension bar to take up the media
• Tension bar is located on both the feeding side
and the take-up side. You can select between
Use/Do not use for feeding tension bar and
take-up tension bar separately. (
P.2-4)
50% of the maximum 100% of the maximum
Scale of the torque
Adjustment nut