– 3.52 –
Perform cutting with a dotted line [HALF CUT]
When cutting the sheet according to data, the device cuts the data in broken lines without cutting it
out.
In addition, the “auto cut” can be specified to cut out the sheet automatically upon completion
cutting. To conduct the broken-line cutting, place the tool on this side of the tool holder and set the
cutting conditions to “HALF.”
* For the broken-line cutting, use the cutter (model: SPB-0001, a set of three
cemented carbide blades) that is optionally available.
* In case performing dot-line cutting on the pen line rubber, the blade tip may
be damaged.
* Since the broken-line cutting cuts the media together with the base paper,
the life of the cutter blade used for broken-line cutting will be shorter than
that of the one used for normal cutting.
Setting value
Half cut (Setting of broken-line cutting)
: ON, OFF
Half cut press (Cutting pressure of sheet to remain after cutting) : 0 g to 80 g
Half cut length (Length of sheet to remain after cutting) : 0.1 mm to 5.0 mm
Cut length (Length by which the sheet is cut out.)
: 5 to 150 mm
•
Reference value
Cutting conditions and broken-line cutting conditions for the case where the
sheet that weighs 65 kg is cut are as follows:
<Cutting conditions>
<Broken-line cutting conditions>
• SPEED
40 cm/s
• Half cut press
0 g
• PRESSURE
40 g
• Half cut length
0.5 mm
• OFFSET
0.30 mm
• Cut length
10 mm
Set the “ CUT LENGTH” to a comparatively small value when cutting a
character with many strokes or small-size character.
Side view of the sheet
Cutting length:
Cutting is performed with a pressure
specified in the cutting conditions.
Half-cut length:
Cutting is performed with a half-
cut pressure.
Sheet
Cutter
Содержание CG-FX SERIES
