– 2.17 –
Loading a roll sheet
In the case where a roll of sheet is used, roll stays are required to be mounted on the device.
Refer to Assembling Instructions.
1) Attach the roll bar assembly to the roll stays.
Place the roll bar assy. in the slit 1 or 2 according to the
outside diameter of the roll sheet to be used. Fit the turn-
back lever
•
If the outside diameter of the roll sheet is 3
inches or more, put the roll bar assy. in the slit 1
and 2.
•
If the outside diameter of the roll sheet is 3
inches or less, put the roll bar assy. in the slit 2
and 3.
2) Load a roll sheet.
Place a roll sheet on the roll bar, pass the top end of the
sheet through the platen and change the location of the pinch
rollers according to the sheet width.
*
Change the location of the pinch rollers so that
each one is placed 5 mm or more inside the
sheet width. If not, the sheet can slip off the
pinch rollers while it is being fed.
3) Secure the roll sheet with the roll holder.
Move the respective sheet set rings to the rightmost and
leftmost ends of the roll sheet and fix them by tightening
screws to secure the roll.
*
Fix a roll holder 2 - 3 mm apart from a sheet
end. In case fixing the both ends too tight, sheet
feeding may not be performed normally.
3
1
2
Roll bar
Roll stay assy
Содержание CG-FX SERIES
