26
5.
Establish a new origin.
Move on the sheet using the jog
key (arrow key) to establish an
origin.
If the sheet has no space for
cutting, replace the sheet with a
new one.
6.
Press the
REMOTE
key to set
the device in the remote
mode.
Feed the sheet by the maximum
sheet length required by data on
cutting and start cutting.
When the sheet is too short to feed,
the error message below will be dis-
played.
Change to a larger sheet according
to step 5.
7.
Carry out steps 5and 6 in
repetition.
Repeat those steps continuously
until there is no data that exceeds
the sheet width.
Upon completion of those steps,
the LCD display will give the tool
conditions.
Division cut
margin
1 cm
1.
Set the [DIVISIONcut] to
the ON state.
2.
Send data from the host
computer to the device.
If the data exceeds the cutting
area, the display given on the left
will appear on the LCD.
3.
Upon completion of
cutting, wait until the
device cuts the frame and
adhesion allowance mark.
Remaining time until the
completion of cutting the frame
and mark.
4.
Upon completion of the
frame cutting, the device
will enter the local mode.
The display shown on the left
will appear on the LCD panel.
Origin
Effective
area
Mark
*
Division cut [DIVISION CUT]
In the case where the data on cutting exceeds the sheet width, the device is able to cut the data with divided appropriately. In the case where
the rotating function is set to the ON state, the result will be as illustrated below.
• Setting value (Make a choice and input it)
A
B
A
B
Rotating function: OFF
Rotating function: ON
Division cut
margin
• Frame cut is not
specified on the host
computer side.
• Frame cut is
specified on the host
computer side.
DIVISION CUT
: ON, OFF
FRAME CUT
: ON, OFF
MARK CUT
: ON, OFF
In the case of the frame cut or division cut margin, the device will
perform cutting based on the size of data on cutting. If the host
computer designates the frame cutting and sends data to the
device, the frame will align with the adhesion allowance marks to
facilitate adhesion.
• While the device is engaged in division cut, it
will ignore other data sent from the host
computer.
• The sheet has an adhesion allowance of 1 cm.
It is, therefore, necessary that the effective
cutting area shall be wider than 1 cm at all
times.
In any of the following case, the device will cut neither the frame
nor the division cut margin.
• Where the capacity of data is larger than the receiver buffer
capacity
• Where the origin updating command is contained in the data
on cutting
• Where the two-point correcting function is specified
• Where the width of effective cutting area is 1 cm or less
• Where the device cuts the test data stored in it the following
display will appear on the LCD panel.
Frame
**OFF SCALE **
The time required to cut the frame
and the division cut margin will
apper on the LCD panel.
CUT1 20 050 0.30
CUT1 20 050 0.30
ERR15 AUTO FEED
** END DIVISION **
** DIVISION ** XXs
Origin
Origin
