17
Starting cutting (plotting)
Start cutting after installation of tool and sheet, and tool condition setting.
1.
After the set of the origin, press the
REMOTE
key.
The display on the LCD will change over to the remote mode.
2.
Send data from the host computer to the device.
Once the device receives data, the device will give the remaining amount of data while performing
cutting.
When the device completes cutting, the display shown on the left will appear on the LCD.
CUT1 * 1356 K B *
• When saelecting the cutter
• When aselecting the pen
Putting the cutting (plotting) on hold
To temporarily stop the device during cutting, press the
REMOTE
key once. Another press on the
same key will allow the device to resume cutting.
• If any function that initiates some action or any operation that can
affect the command coordinate system is executed during a pause
period, the error message shown below will appear on the LCD.
In the event that the error message appears on the LCD, press the
REMOTE
key to cut the remaining
portion of data or execute data clear.
• In case the sheet is off from the pinch roller while cutting,
immediately turn off the power switch.
• When the sheet is almost out of the pinch roller, press REMOTE key to
halt the machine and execute the DATA CLEAR (or turn off the power
switch) Then press SHIFT SET key to reset the sheet. (--->P.12,13)
CUT1 ** REMOTE **
CUT1 ** REMOTE **
PEN ** REMOTE **
ERR34 DAT REMAIN
