Miller FieldPro Feeder CE, Руководство пользователя

Страница: 20 / 44

OM-267043 Page 14
Associating the FieldPro t Feeder to
the PipeWorx 350 FieldPro t power
source:
1 Connect the feeder to the weld
circuit as you would a traditional
voltage − sensing wire feeder.
Feeder must be in CV mode to
work with FieldPro t System
(See Section 6-1).
2 Turn on the welding power source
and wire feeder. The welding
power source will display the last
amperage set point and the wire
feeder will display three dashes
until connected. Allow 10 − 15
seconds for system to connect.
3 Once feeder is communicating
with power source, the power
source will display “Acc” and the
wire feeder will display preset
voltage and wire feed speed.
4 The preset welding voltage and
wire feed speed can now be
adjusted with the voltage control
on the wire feeder while not
welding.
While welding, the wire feeder
displays weld voltage at the
feeder. The power source displays
amperage from feeder while
welding and will display amperage
for 10 seconds after welding.
5-4. Equipment Setup
255 911-A / Ref. 805 200-B / Ref.259 046-B
123
Acc
---
24.0
15.5
24.0
15.5
---