Miller FieldPro Feeder CE, Руководство пользователя

Страница: 19 / 44

OM-267043 Page 13
SECTION 5 − INSTALLATION
5-1. Equipment Connection Diagram
258 966-A / Ref. 257 819-B
3
5
6
10
2
8
9
1
4
!
Turn Off wire feeder and
welding power source.
!
Do not move or operate
equipment where it could tip.
1 Welding Power Source
2 Gas Hose
3 Weld Cable To Feeder
4 Work Cable To Workpiece
Weld cable and work cable connec-
tions to power source (DCEN/DCEP)
are dependant on wire type.
Power source is configured for
DCEP. To run DCEN manually swap
cables.
.
Since feeder is not polarity sensi-
tive, there is no need for an elec-
trode polarity switch.
5 Workpiece
6 Voltage Sensing Clamp
Connect voltage sensing clamp to
workpiece.
7
Gun
8 Gun Trigger Receptacle
9 Wire Feeder
10 Gas Cylinder
Use of shielding gas is dependant on
wire type.
.
Shielding gas pressure not to ex-
ceed 100 psi (689 kPa).
7
5-2. WCC (Weld Cable Control) Applications
.
To take advantage of the WCC features, the FieldPro t Feeder must be used with a PipeWorx 350 FieldPro t power source.
5-3. Associating Wire Feeder To PipeWorx 350 FieldPro t
1 Connect feeder to PipeWorx 350 FieldPro
t
.
2 Do not strike an arc.
3 Feeder will display dashed lines and CCV until connected.
4 Once connected the feeder will display voltage.
5 Use voltage control on feeder to adjust weld voltage.
6 The voltmeter will alternate between preset voltage and open circuit voltage while idle or weld voltage at the wire feeder while welding.
.
See Section 5-4 for detailed equipment setup.