Page 2-3
Chapter 2: Heating System Overview and Adjustments
|
Section 2.1: Hot Air Heating System
Preliminary Steps Before Adjusting The Nozzle
Below are the steps that need to be taken before adjusting the nozzle
NOTE:
The Nozzle angle must be adjusted prior to step 1 while the Nozzle is cold to
avoid personal injury. (See
"Adjusting Nozzle Angle"
on page 2-2.)
1. Preheat the Hot Air Heating System to the desired welding
temperature by turning the Power and Heat Switches to the on
position. The Nozzle will expand as the temperature is increased
changing its position on the Weld Rollers.
2. Set the Weld Roller Pressure to desired setting, so that the Weld
Roller Pinch Point is set.
(Figure2.4)
3. Turn the Master Speed Control to “000” to insure the Weld Rollers
will not turn.
(Figure2.5)
4. Depress the Drive Foot Switch to swing Nozzle into place and
insure it will not hit the Weld Rollers. If the Nozzle should hit,
release the Drive Foot Switch and turn the Depth Adjustment
Knob counter clock-wise to move the Nozzle back away from the
Weld Rollers so it does not hit.
5. Turn the Master Speed Control to “100” to activate the Weld
Rollers.
(Figure2.6)
Figure 2.4:
Figure 2.5:
Figure 2.6:
Содержание T-100
Страница 1: ......
