Page 1-2
Chapter 1: Machine Overview
|
Section 1.2: Electrical and Air Requirements
•
Only a properly trained technician may perform any repairs to the T-
500 and T-100.
•
Only manufacturer approved replacement parts are to be used for
the T-500 and T-100.
NOTE:
The manufacturer will not be held liable for any damage or injuries occurring
from any inappropriate use of this machine.
Section 1.2: Electrical and Air Requirements
Warning!
Only a qualified electrician may connect the
electrical power.
Module 1.2.1: Electrical Supply
The Miller Weldmaster T-500 and T-100 includes a power cord that
is approximately 6 feet in length. Due to the number of different
style outlets available, the cord will not include a plug. You may
choose to have your power cord hard wired into your power supply. It
is recommended that your electrician use a junction box with an on/
off switch.
The Miller Weldmaster T-500 and T-100 are available in both single
phase and three phase power, refer to your quotation for this
specification.
The Miller Weldmaster T-500 and T-100 require the following
electrical requirements:
•
208/240 volts
•
50Hz or 60Hz
•
40 amperes
If using the Miller Weldmaster T-500 and T-100 with a carriage,
this requires the following electrical requirements:
•
208/240 volts
•
50Hz or 60Hz
•
60 amperes
Module 1.2.2: Shop Air Supply
The Miller Weldmaster T-500 and T-100 include an In Shop Air
Supply Valve that allows quick connects and disconnects to your shop
air supply. Due to the number of different style airline connectors, a
male quick connect is not included. You will want to select a male
quick connect with a ¼ inch NPT (National Pipe Thread) to match
Содержание T-100
Страница 1: ......
