Page 2-10
Chapter 2: Heating System Overview and Adjustments
|
Section 2.2: Wedge Adjustment
Tilt of Wedge
The Tilt of the Wedge is the vertical angle at which the wedge Tip is positioned in
relationship with the weld rollers. This relationship must be parallel (or level) with the
pinch point of the weld rollers. When the wedge tilt is out of adjustment the seam will be
uneven across the width of the weld. Check the Tilt of the Wedge and if not properly
placed proceed with the following:
(Figure2.27)
1.Loosen the 2 clamping collars on the
Pivot Shaft for the Air Cylinder Mounting
Bracket.
(Figure2.28)
2.Pivot the Wedge Assembly until the Tilt
of the Wedge is properly aligned in
relationship with the Weld Rollers.
3.Securely tighten the clamping collars.
Check to see if the proper tilt
adjustment of the Wedge has been
made.
(Figure2.29)
Repeat steps 1
through 3 until correct.
Figure 2.27:
Figure 2.28:
Figure 2.29:
Содержание T-100
Страница 1: ......
