Miller Electric Spectrum Plus, Руководство пользователя

Страница: 25 / 44

OM-219 Page 21
4-4. Trouble Lights
1 Trigger Light
Lights when torch trigger is
pressed.
2 Transfer Light
Lights when the transfer from pilot
to plasma arc occurs. Stays lit as
long as plasma arc is present.
If certain problems occur, the
Transfer light goes off, one of the
following trouble lights comes on,
and output stops.
3 Gas/Torch Light
Lights if gas/air pressure is low and
stops plasma and pilot arcs. Also,
lights if torch tip is not installed
when trigger is pressed. Check for
proper gas/air pressure, and torch
tip (see torch Owner’s Manual).
4 Temperature Light
Lights if cutter overheats (see Sec-
tion 2-2).
5 Polarity Light
Lights if polarity of welding power
source/generator connections to
cutter is incorrect. Check connec-
tions (see Section 2-8).
1
2
3
4
5
POLARITY
TEMPERATURE
GAS/TORCH
TRIGGER
TRANSFER