Mikrotron EoSens CAMMC1186, Справочное руководство, Страница: 25 / 98

The 1.1CXP Camera
MIKROTRON GmbH 3 ‐ 7
Connecting an External Power Supply or I/O Signals
In case you prefer an external 12 ‐ 24V DC power supply (min. 18 W),
connect it with the 12 pin Hirose connector at the rear of the camera.
WARNING! The power connector of the camera has to be connected
with a DC power supply providing 12 to 24 V DC. Con
‐
necting a lower or higher supply voltage, an AC voltage,
reversal polarity or using wrong pins of the power con
‐
nector may damage the camera and will void warranty!
MIKROTRON offers the power supply unit NTCAM132xx with cables of
5 or 10 meters. In case you assemble your own cable, pay attention to
the pinning described below.
12 Pin Hirose Connector and I/O Signals
When connecting an external power supply for MC1186/MC1187 connect it
with the 12 pin Hirose connector (HR10A
‐ 10R ‐ 12PB (71)) of the camera.
The DC power supply has to deliver 12 ‐ 24 V DC (7 W)
and has to be
equipped with a HR ‐ 10A ‐ 10P ‐ 12S plug
.
The 12 pin connector provides two inputs for an external trigger and one
output signal. The output signal can be controlled. For more information
see "
LineSource
" on page 12 ‐ 9.
Note The I/O standard 3.3V LVTTL applies to all signal I/Os.
Tip: Note that the voltage of
the low level has to be
< 0.3 V.
When connecting an external trigger, it might be helpful to know how
the OUT and IN pins are internally connected.
Table 3 ‐ 1: Pinning of the 12 pin power connector
Pin Signal Pin Signal
1 + 12 GND 6 IN0
2 + 11 VCC
(8 ‐ 24 V)
7 IO
GND
3 IO
GND
8 OUT1
4 OUT0 9 IO
GND
5 IO
GND
10 IN1
Solder side