Miele PWT 6089 Vario, Инструкции по эксплуатации и монтажу, Страница: 63 / 96

Problem Possible cause Remedy
E
Clean out airways
Clean the lint filters
Check ducting
appears at the end
of a program.*
There is a blockage
in the ducting system. – Clean the lint filter.
– Check all possible causes
given under "The drying
process goes on too long or
even switches off."
To delete the message:
– Open and close the door.
The vent ducting may
be very long, which
does not constitute a
fault. – If very long ducting is used,
then program times will be
longer and energy
consumption higher.
E
Clean out airways
Clean the lint filters
Check ducting
F66
appears after a
program has been
canceled.
There is a very severe
blockage in the
ducting system. – See above.
To delete the fault message:
– Confirm with
OK .
To continue a program
after a power cut Power cut. – Confirm the message shown
in the display by pressing
shortcut button
D
and
then press the Start button.
The program will then
continue with the next
program stage.
The washer-extractor
was switched off and
then back on again
with the
On/Off
button.
Problem solving guide
63