Midway Cruis'n Exotica, Руководство по эксплуатации

Страница: 99 / 109

Troubleshooting - 9
Player Control Troubleshooting Table
SYMPTOM CAUSE REQUIRED ACTION
Faulty switches or
lamps 1. Press and hold TEST MODE switch inside coin
door to enter Menu System. Select SWITCH
TEST from Diagnostic Menu. Conduct tests to
confirm switch operation.
2. Press and hold TEST MODE switch inside coin
door to enter Menu System. Select LAMP TEST
from Diagnostic Menu. Conduct tests to confirm
lamp operation.
3. Check for loose parts or wires caught in switch
contacts.
4. Check continuity at each switch connection
(Common to Normally Open or Common to
Normally Closed).
5. Verify player control operates properly by placing
it in working VGM.
6. Verify light bulbs used for dashboard switches
are type specified in parts listing. Other types will
light, but may produce too much heat. Excess
heat may cause switches to bind.
•
Intermittent or completely
non-functional player
controls
•
Video Game Machine (VGM)
starts normally.
Faulty switch wiring 1. Check for wires caught in door hinges, latches,
or switch contacts.
2. Verify harness connectors are attached and fully
seated.
3. Assure control switches connect properly to
control input wires.
4. Check cabinet wiring is correct for this VGM.
•
Steering pulls to one side
Faulty Wheel Driver
Board Find power amp on Wheel Driver Board’s large
heatsink. Test and replace bad part or board.
Improperly set
feedback
1. Select STEERING WHEEL TEST on the
Diagnostics Menu.
2. Set feedback to match player requirements.
Maximum force may be too extreme for very
young or inexperienced customers.
Faulty circuit
1. Examine fuses and cables on Wheel Driver
Board.
2. Check cables and wiring between CPU board,
wheel driver and motor.
3. Check resistance of motor series resistors.
4. Replace bad parts.
•
No wheel feedback
•
Steering aims vehicle as
expected
Faulty motor
1. Turn off power. Open dashboard. Support
steering wheel and remove outer mounting
screws.
2. Remove metal shield (if VGM has one) over
motor.
3. Unscrew caps.
4. Inspect motor brushes. Replace worn parts.