Service manual for Wash and Dry Combo product
Midea America Company
-------------------------------------------------------------------------------------------------------------------------------------------------------
－
12
－
4. Additional spacing of 1 inch (25mm) on all sides of the washer is recommended.
5. Companion appliance spacing should also be considered.
Unpacking the washing machine
Be sure to remove all packaging foams from the carton box including the foam supporting the inner
drum.
Remove transport bolts
Before using this washing machine, transport bolts must be
removed from the backside of this machine. Please take the
following steps to remove the bolts:
1. Loosen all bolts with wrench and then remove them.
2. Cover the holes with transport hole plugs.
3. Keep the transport bolts properly for future use.
Connect the inlet hose and drainage hose
Connect the inlet hose. Be sure the hot water hose is
connected correctly.
Connect the drainage hose.
Standpipe drain system -wall or floor (views A & B). The standpipe drain requires a minimum
diameter standpipe of 2 inch (5 cm). The minimum carry-away Capacity can be no less than 17 gal.
(64 L) per minute. The top of the standpipe must be at least 24 inch (60cm) high and no higher
than 40 inch (100cm) from the bottom of the washer.
Laundry tub drain system (view C). The laundry tub needs a minimum 20 gal. (76 L) capacity. The
top of the laundry tub must be at least 24 inch (60cm) above the floor.
