Service manual for Wash and Dry Combo product
Midea America Company
-------------------------------------------------------------------------------------------------------------------------------------------------------
－
16
－
t10
When “t10” is displayed on LED, “Spin check” function can be activated by pressing the
“Start/Pause” button. The display shows the velocity. The spin velocity will soon go up to
400rpm. Press the “Start/Pause” button again the machine will escalate run to the speed
of 1000 rpm. Press the “Start/Pause” button the third time the spin velocity will soon get up
to 1120rpm and hold for 30 seconds. Then the unit will stop.
t12
When “t12” is displayed on LED, “Water Valve check” function can be activated by
pressing the “Start/Pause” button. Then “U2” will be displayed on LED with main wash
valve opened for 5 seconds.
Press the “Start/Pause” button again. “U1” will be displayed with Pre-wash valve
opened for 5 seconds.
Press the “Start/Pause” button thirdly. “U3” will be displayed with hot water valve
opened for 5 seconds.
Press the “Start/Pause” button the fourth time. “U4” will be displayed with only
condensing valve opened for 5 seconds.
Press the “Start/Pause” button the fifth time, “U12” will be displayed with Pre-wash valve
and main wash valve work for 5 seconds at the same time.
4.3 Error codes
Error
Code
Error
description
Unit Action
Possible
Cause
Solution
In 7 minutes,
the water level
Unit will close
Low Water
Pressure from
House Supply
If the washer fills very slowly, the
water pressure from the house
might be too low. If the water inlet
valve isn't leaking and there are
no other symptoms this problem
does not need to be corrected.
Water inlet
hose
Make sure that water faucet is
turned on and that the screens on
the hoses are not restricted.
Water inlet
valve
(The voltage on
the water inlet
valve is normal)
If the water pressure is good, try
cleaning the screens inside the
water inlet valve hose connection
ports. If those are clean replace
the water inlet valve.
