Microtronics myDatalogGauge 3G, Руководство пользователя

Страница: 84 / 158

Note:
Additional explanation on the zero point adjustment and installation height of the pressure sensor
Assumption: Pressure sensor 0-1 m
Installation situation of the pressure sensor
1 Installation height: 15 cm 3 Output value of the pressure sensor: 6 cm
2 Pressure sensor 4 Measured fill level: 20 cm
Parameter Value
Trimming -0.01
Sensor offset 0.15
Unit m
Required configuration
Explanation: When comparing the measured fill level with the output value of the pressure sensor taking the
installation height into consideration, it was determined that the value was 1 cm too high. As the "Trimming"
and "Sensor offset" parameters are added to the measurement value, this error can be balanced out by setting
the "Trimming" parameter value to -0.01 m.
10.2.1.1.4.2 Alarms
"Measurement channels" configuration section, "Alarms" tab
1 A warning is triggered, if the measurement value drops to or below this value.
2 A warning is triggered, if the measurement value meets or exceeds this value.
3 An alarm is triggered, if the measurement value drops to or below this value.
4 An alarm is triggered, if the measurement value meets or exceeds this value.
5 Hysteresis for all-clear in event of alarm/warning (e.g. hyst = 5%, alarm or warning at 100 -> all-clear at
95)
84 Rev. 01