MHSC 400BBNSC, Инструкция по установке и эксплуатации, Страница: 23 / 48

BBV, SBV Series Natural Vent Gas Fireplaces SIGNATURE COMMAND - CHECK GAS PRESSURE and ELECTRICAL INSTALLATION
Figure 25 -
Signature Command Valve
FP1909a
signature command valve
alternate view
8/08
ressure Inlet
ilot d ust
ment cre
ressure utlet
eck as type e as supply must be t e same as
stated on t e appliance s ratin decal I t e as supply
is di erent rom t e ireplace
STOP! Do not install t e
appliance ontact your dealer immediately
o ease installation a mm le line it manual
s ut o valve as been provided it on t is appliance
Install and attac
as line onto s ut o valve
ter completin as line connection pur e air rom
as line and test all as oints rom t e as meter to t e
ireplace or leaks se a solution o ater and
soap solution or a as sni er
o c eck as pressures at valve turn captured scre
counter clock ise or turns and t en place tubin
to pressure au e over test point urn unit to i
igure . ter takin pressure readin be sure and
turn captured scre clock ise irmly to reseal Do not
over tor ue
eck test points or as leaks
Do not use open flame to check for gas
leaks.
ELECTRICAL WIRING
General
is ireplace is e uipped it t e i nature ontrol
valve ic operates on volts e volt D adapter
plu s into t e ireplace unction bo po er supply
our batteries are used or back up durin
po er outa es
e i nature ommand ystem can also be operated
it out po er e system can run on our
batteries or appro imately si mont s under normal
use
Optional Accessory Requirements
is ireplace may be used it a all s itc and or
i nature ommand ireless controls
e command center control may be mounted on t e
all it t e use o t e t all mount e ten
sion kit
W
ARNING
Electrical connections should only
be performed by a qualified, licensed
electrician. Main power must be off when
connecting to main electrical power supply
or performing service. All wiring shall be
in compliance with all local, city and state
codes. The appliance, when installed, must
be electrically grounded in accordance with
local codes or in the absence of local codes,
with the National Electrical Code ANSI/NFPA
70 (latest edition) and Canadian Electrical
Code, CSA C22.1.
CAUTION
Label all wires before disconnecting when
servicing controls. Wiring errors can cause
improper and dangerous operation.
W
ARNING