MHSC 400BBNSC, Инструкция по установке и эксплуатации, Страница: 16 / 48

BBV, SBV Series Natural Vent Gas Fireplaces
CHECK GAS PRESSURE & ELECTRICAL INSTALLATION - MILLIVOLT
eck as type e as supply must be t e same as
stated on t e appliance s ratin decal I t e as sup
ply is di erent rom t e ireplace
STOP! Do not install
t e appliance ontact your dealer immediately
o ease installation a mm le line it
manual s ut o valve as been provided it t is ap
pliance Install and attac
as line onto s ut o
valve
ter completin as line connection pur e air rom
as line and test all as oints rom t e as meter to
t e ireplace or leaks se a solution o ater
and soap or a as sni er
o ad ust lame ei t turn I knob to I to et
ma imum pressure to burner urn I knob to
to et minimum pressure
o c eck as pressures at valve turn captured scre
counterclock ise or turns and t en place tubin
to pressure au e over test point urn unit to i
igure . ter takin pressure readin be sure and
turn captured scre clock ise irmly to reseal Do not
over tor ue
eck test points or as leaks
W
ARNING
Do not use open flame to check for gas
leaks.
&0
-ILLIVOLTGASVALVE
ressure
est I
ressure
est
I nob
ilot d ustment cre
Figure 17 -
Gas Pressure Check at Gas Valve
Electrical connections should only be per-
formed by a qualified, licensed electrician.
Main power must be off when connecting to
main electrical power supply or performing
service. All wiring shall be in compliance
with all local, city and state codes. The ap-
pliance, when installed, just be electrically
grounded in accordance with local codes,
or in the absence of local codes, with the
National Electrical Code ANSI/NFPA 70 (lat-
est edition) and Canadian Electrical Code,
CSA C22.1.
CAUTION
Label all wires before disconnecting when
servicing controls. Wiring errors can cause
improper and dangerous operation.
ELECTRICAL WIRING
W
ARNING
eri y proper operation a ter servicin