Vega EMS-1 Operating Manual
Page 34
HOBBS CODE:
This menu option allows you to change the Hobbs access code. You will first be prompted to enter the current code
followed by entering in a new code followed by re-entering the new code. If the new code and the re-entered code is the
same, then the Hobbs access code will be changed. Default code is 0000.
HOBBS HOUR:
Select if you would like the hour to be displayed in decimal fractions or minutes.
SET MAINT TIME:
This function allows you to set an engine maintenance
timer. This timer is set in engine hours and it will count
down to zero when the engine RPM is greater then the
“
HOBBS RPM”
. A good use for this function is to set the
hours until your next spark plug change or engine
inspection. Use the rotary control to change the value.
H/M Start:
Select what source will start the Hobbs and Maintenance timers. A selection between Power, RPM 1 or RPM 2 can be
made.
HOBBS RPM:
Enter the RPM limit in which the Hobbs timer/Maintenance timer must start incrementing.
