Metos Culino Combi 40S, Инструкция по установке и эксплуатации

Страница: 39 / 58

15.6.2012 Rev. 1.7
Installation
33
5.1.3 Facilities
The kettle can be used in a normal, air-conditioned professional kitchen. The room tem-
perature of the installation place must not 40°C and the relative humidity must
be less than 80% (condensation on surfaces not allowed to occur). If the temperature of
the facility in winter conditions is below 0°C, the steam generator of the kettle must be
drained and the kettle must be emptied to avoid damage caused by freezing. The kettle's
pipes and solenoid valve bodies must be emptied at the same time.
5.1.4 Unpacking the unit
The kettle is transported in its own package as near the installation place as possible be-
fore final unpacking. Remove the plastic foil wrapped round the kettle after the installa-
tion just before the first use of the kettle.When unpacking all packing material must be
sorted and disposed of according to local recycling regulations.
5.1.5 Industrial safety during installation
Beware of sharp edges of sheet constructions in the kettle pillars when installing the unit.
Do not switch the power on, if the unit installation area is wet or moist.
5.2 Installation
Check before the installation from the installation drawing that there is enough space be-
hind the kettle for tilting. Check also the location of the floor drain.
The kettle can be installed in the following two ways:
• on subsurface installation frames, frames cast into the floor
• on surface installation frames, frames fixed between the kettle and the floor
Remove the front panels of the control pillar and support pillar when installing. It is rec-
ommended to put wooden slats below the kettle axles when raising the unit during the in-
stallation to avoid possible falling of the kettle. If you are installing a kettle group, first
separate the kettles. Begin the installation with the left-hand kettle and do not forget to
support the right-hand kettle after removal from the left-hand temporary support.