Meteor Communications Corporation MCC-545C, Эксплуатация и обслуживание, Страница: 57 / 88

OPERATIONS 4-21
MCC-545C PACKET DATA RADIO
12/2000
MCC-545C COMMANDS
COMMAND DESCRIPTION PARAMETERS RANGE
†*ASSIGN
{,function,port,protocol
{,timeout}}
NOTE
function, port and protocol
information for ports 0, 1,
2 are stored in EEPROM;
this information for port 3
and all timeout information
is stored in BBU RAM.
Control allocation of user interface functions among
physical device channels. When no parameters are
entered, displays I/O configurations. Port definitions are
as follows:
Front Panel
Port Connector
0
OPERATOR PORT
1 DATA PORT
2 AUXILIARY PORT
3 DIAGNOSTICS PORT (Internal)
NOTE
It is possible to “lose control” of the MCC-545C
software by assigning control functions to ports with no
devices attached or by turning off control functions. For
example, if you turn off the Operator Port
(
ASSIGN,MNT,OFF ), you will not be able to enter
commands or view printouts from the MCC-545C. You
must open the MCC-545C and press the Reset button on
the microprocessor board to re-enable the Operator Port.
function = user
interface function
port = physical
device channel
protocol = link
level protocol
timeout in
seconds
MNT, POS, MSG,
ALT, DTA, C&S,
0-2, OFF
APCL5, ASCII,
CR10X,
DATALITE, ENAV,
FWS, GPS, GYRO,
IDA, IHS, MSC,
PHAROS, PKT,
RTCM, TM8T
0 – 32767
*BASE {,nnn,nnn} Set display range of Master Station IDs reserved for use
as Base Stations nnn = Master
Station ID
OFF = no Bases
2 – 245
BINS Print link distribution statistics
BOOT
Cold start of Station software. All volatile memory is
lost.