PN T900-014, Rev B
Powering Up the ta7000F Gas Purity Monitor
Do not continue with this procedure until the ta7000F Monitor instal-
lation is complete.
Adjust incoming gas supply pressures as specified in the Specifications chapter
(refer to Inlet Pressure Range).
Power up the ta7000F Monitor by pressing its AC Power Switch (on the Rear
Panel) to the On (“
–
”) position. The
Power/Status
LED on the front panel will
turn On (GREEN) and the rear cooling fan should begin operating. The initial
start-up screen should appear within a few seconds.
If any of these does not
occur, turn the power Off immediately and contact AMETEK Customer Service
or your local authorized service agent.
Figure 2-6.
Initial screen at power-up,
ta7000F Monitor User Interface.
Installation and Start-Up
|
2-17
