Metallkraft ULMS 420, Инструкция по эксплуатации

Страница: 9 / 40

Transport, Packaging, Storage
ULMS-Series | Version 2.04 9
Noise level
Normative reference: The noise levels generated by the
machine are based on the working conditions listed
below. EN ISO 3744 test equipment: TES 1351.
4.2 Type plate
Fig. 6: Type plate ULMS 420
5 Transport, Packaging, Storage
5.1 Delivery and Transport
Delivery
Check the Automatic light alloy metal-cutting saw for vi-
sible transport damage upon delivery. In case of visible
damage to the Automatic light alloy metal-cutting saw,
immediately notify the carrier or your retailer.
Transport
Improper transport is accident-prone and can cause da-
mage or malfunctions for which we do not grant any liabi-
lity or guarantee.Transport the scope of delivery secured
against shifting or tilting with a sufficiently dimensioned
industrial truck to the installation site
For transport, the machine must be secured in accor-
dance with the regulations on the loading area. All loose
parts must either be fixed to the machine, secured sepa-
rately or stowed in a separate, secure container.
The Automatic light alloy metal-cutting saw may only be
loaded and unloaded by qualified specialist personnel.
Test conditions ULMS 420 ULMS 500
Saw blade dia-
meter [mm] 420 500
Saw blade
speed [1/min] 2900 2347
Cutting angle [°] 90 90
Used material aluminum aluminum
Dimensions of
the material
(L x w x h) 2000 x 20 x 70
mm 2000 x 20 x 70
mm
Values while working
workplace-related
noise level (LvA) 92 dB 92 dB
Measurement
uncertainty (K) 2 dB 2 dB
WARNING!
Ear protection must be used as the sound level
during work may exceed 80 dB.
Failure to do so may damage your hearing!
WARNING!
Severe or fatal injuries may occur if parts of the
machine tumble or fall down from the
forklift
truck, pallet truck or from the transport vehicle.
Follow the instructions and information on the trans-
port box.
Note the total weight of the machine. The weight of
the machine is indicated in the "Technical data" of the
machine. When the machine is unpacked, the weight
of the machine can also be read on the rating plate.
Only use transport devices and load suspension gear
that can hold the total weight of the machine.
WARNING!
The use of unstable lifting and load suspension
equipment that might break under load can cause
severe injuries or even death. Check that the lifting
and load suspension gear has sufficient load-bea-
ring capacity and that it is in perfect condition.
Observe the accident prevention regulations issued
by your Employers Liability Insurance Association or
other competent supervisory authority, responsible
for your company.
Fasten the loads properly.
NOTE!
Protect the Automatic light alloy metal-cutting saw
against moisture.
WARNING!
Danger to life due to falling of the
load!
Falling loads can cause serious injury or even death.
- Never step under suspended loads.
- Fix loads carefully.
- When leaving the workplace, lower the load.
- Absolutely avoid that the load gets into commuting.