Metallkraft ULMS 420, Инструкция по эксплуатации

Страница: 11 / 40

Assembly and Installation
ULMS-Series | Version 2.04 11
1 Cover with safety switch
2 Control panel
3 Pin for turning the turntable
4 Length stop
5 Scale for setting the stop frame
6 Clamping device
7 Turntables
8 Locking pin to snap in for fixed cutting angle positions
9 Miter angle scale on the turntable
10 Speed adjustment
11 Workpiece stop
12 Compressed air maintenance unit with pressure
gauge (on the side)
13 Compressed air connection (rear)
6.2 Scope of delivery
- 2x saw blade 420x30x4 mm Z96
(Model ULMS 420)
- 2x saw blade 500x30x4 mm Z120
(Model ULMS 500)
- Operating tool
- Coolant tank
- Compressed air gun and spiral hose
- Operating manual
7 Assembly and Installation
7.1 Set up
Requirements for the installation site
The machine is factory-installed and delivered to the cu-
stomer.
To ensure good functionality and a long service life of the
Automatic light alloy metal-cutting saw, the installation
site should fulfil the following criteria:
- The Automatic light alloy metal-cutting saw may
only be set up and operated in dry, frost-free, well-
ventilated rooms.
- Avoid places near chips or dust generating machines.
- The place of installation must be vibration-free, ie
away from presses, planing machines, etc.
- The substrate must be suitable for the work. Pay atten-
tion to carrying capacity and evenness of the subsoil.
- Protruding parts, such as support tables, stops,
etc., are to be secured if necessary by on-site mea-
sures so that persons are not endangered.
- Provide sufficient space for set-up and operating
personnel and material transport.
- Also consider the accessibility for adjustment and
maintenance work.
- Ensure adequate lighting (minimum value: 300 lux)
- The machine must be set up in a well-ventilated room.
Setting up the Automatic light alloy metal-cutting
saw
Model ULMS 420 and ULMS 500
Step 1: Check the surface with a spirit level for horizontal
alignment, if necessary, compensate for slight
unevenness.
Step 2: Place the supplied plastic feet in the respective
mounting slot (Fig. 8 or 9).
Step 3: Place the Automatic light alloy metal-cutting saw
on the flat, firm and vibration-free ground.
Step 4: Level the machine over the feet (Fig.8 or 9).
Fig. 8: Installation of the feet on model ULMS 420
WARNING!
Before you set up the machine, check the load-bear-
ing capacity of the substrate. The installation site
must be able to bear the weight of the machine inclu-
ding all customer-supplied parts and add-on equip-
ment, as well as the operator and the materials.
Wear suitable safety gloves!
Wear safety shoes!
Wear protective clothing!
NOTE!
The machine must be well balanced on the ground
for efficient use.
It is important that the machine is placed in a well-
ventilated area with sufficient space for easy cutting.