Metal-Fach Z587, Руководство по эксплуатации

Страница: 34 / 52

34
OPERATING MANUAL - Z587 BALER
Maintenance and adjustment
5.5. PICKUP CAM ADJUSTMENT
Depending on the collected material and work conditions, adjust the
pickup cam to prevent the pickup from pulling in the material. Do the
following:
1. Remove the bolts and the pickup left-hand side guard.
2. Loosen the 4 bolts on the cam.
Fig. 33. Pickup cam adjustment.
Adjust the cam position: turning the cam moves the pickupprongs to
or from the conveyor.
Turn the cam:
In the direction "A" to move the cam away from the pickup assembly.
In the direction "B" to move the pickup fingers to the pickup assembly.
Fig. 34. Pickup cam adjustment.
5.6. REPLACEMENT OF THE SAFETY SHEAR BOLT ON
THE PICKUP
If the safety bolt on the pickup is shorn, replace it with an identical
one, i.e. M6x40-10.9 Allen bolt PN-EN ISO 4762:2006 (non-galvanized,
partial thread).
• Remove the baler left-hand side guard.
• Remove the shorn safety bolt and check that no bolt debris are
between the drive parts.
• Realign the safety holes together by manually turning the feeding
screw, insert the new safety bolt and tighten it.
• Reinstall the guard in place.
Fig. 35. Replacing the safety shear bolt.
5.7. REPLACING THE SAFETY SHEAR BOLT OF THE
FEEDER SYSTEM
If the safety bolt on the baling drums is shorn, replace it with an
identical one, i.e. M8x35-8.8 PN PN-EN ISO 4018:2011.
• Remove the chain transmission left-hand bottom guard.
• Remove the shorn safety bolt and check that no bolt debris are left
in the drive.