Metal-Fach SEG BIO 100, Эксплуатационная и техническая документация, Страница: 34 / 54

33
31. Operating requirements
(USER)
The assembly and disassembly of the feeder and its elements should not be forced. No pressure
and vibrations are allowed and the whole unit should be carefully levelled. The connecting surfaces
should be smooth and clean. A long-lasting overload, which is prevented by the pin, is not allowed.
The feeder must be disconnected from the power line before performing any maintainance and
cleaning.
TIP!
The fuel feeder room should be well ventilated and free of intensive heat sources
(radiators, electric fires etc.) in its vicinity. The temperature in the room should not
be lower than 0C and not exceed 40C.
32. Installing the feeder in the boiler and
start-up
(INSTALLER)
ATTENTION
The installation of the feeder should be performed only by a certified company
specialising in assemby and maintenance of electric systems. Any installation works
performed by an unauthorised persons releases the manufacturer from lability and
warranty.
During connecting the feeder to the boiler, ensure that:

the screw shaft is well-levelled
 all the screws are tightened to prevent any loosing-up
 put the plug into the socket located at the bottom of the boiler

during installing the multi-fuel burner, secure the mounting plate with heat- resistant
silicone of resistance of 1250C.
33. Installation and replacing the overload
clutch arrester
(USER/INSTALLER)
The trough burner does not require any specialist operation. It is a self-operating device which
feeds the fuel to the burning area. In case of fuel of too big grains or containing too much unwanted
waste the 125 Nm torque limiting screw might fall off and damage the motoreducer. In such case
the warranty is void.
ATTENTION!
Replacing the pin does not fall under the warranty and can be performed by the
user following the manual. Replacing the pin does not make the warranty void.
Before replacing the pin make sure that the boiler is disconnected from the power
line and all the works must be done carefully and precisely.
The arrester for the overload clutch that limits the torque to 125Nm is a screw with cylindrical
head and DIN 6912 M5 X 50 hexagonal nest of 5.8 mechanical properities class. There are 3 pins
delivered with the motoreducer.
Protection element (locking screw)
1. Remove the plastic cover from the
mechanism