2. Installation
10 NCR875E(H)/NCR875PRO(H)
l
User Manual
2. Installation
Tip
Caution
Warning
Note
The front and rear cap should NOT be removed over 30 minutes during installation. Otherwise, the desiccant
will absorb too much moisture and thus cause vapor.
2.1 Inserting Memory Card
1. Loosen the two sunshield fixing screws and remove the sunshield.
2. Loosen the three screws to remove the mounting bracket assembly.
3. Loosen the three screws to remove the rear cap from the main body.
4. Insert your microSD/SDHC card into the slot.
Tip
Caution
Warning
Note
When inserting the memory card, make sure not to disconnect any cables attached to the camera.
5. Assemble the rear cap and the mounting bracket.
2.2 Mounting the Camera
1. Drill mounting holes and insert anchors.
In desired location, use the supplied Guide Pattern to drill three 5mm mounting holes. Then insert the
supplied anchors into the holes.
2. Pass all the signal cables through the hole for the cables.
Optionally connect a video monitor to the BNC connector if you want to perform focus/zoom adjustments
during the installation.
3. For static electricity protection, ensure that the rubber pad is placed inside the mounting bracket base.
4. Place the three provided insulation caps onto the three tapping screws. Insert the screws to the screw
holes on the camera bracket, and then tighten the screws to the anchors to attach the camera.
