-26-
U.motion Client Touch 7
Technical Manual
The selection popup of the external units – besides the default entry “RITTO” - contains the entry „Manual
Config.“, which permits the integration of external units, whose type is not directly supported. In both cases,
beneath the fields already described on the previous page, also the following 4 entries will be shown for the
external unit:
-
DTMF - Accept:
DTMF tone for starting the conversation
-
DTMF – dooropener:
DTMF tone to control the door opener, is connected to the KEY-
icon in the app
-
DTMF - Hangup:
DTMF tone for closing the conversation
-
DTMF - auxiliary (optional):
DTMF tone to control the auxiliary relay, is connected to the LIGHT-
icon in the app
When selecting the RITTO template, those values will already be filled out, where “x” will be used for both
“Accept” and “Hangup” (and therefore the DTMF tone will be ignored), “*8” will be used for the dooropener
and “*9” will be used for the auxiliary contact. Those values can be freely adapted, as also for the manual
configuration. The main difference when using the manual configuration, is therefore that the IP address of
the camera must be inserted as full path to the motion-jpeg stream of the camera instead of only using the
bare IP address.
Note
: please give special attention to the allocation of the VoIP IDs of the external units: only if the
external unit effectively uses the VoIP ID, for which the configurations have been made, the camera
signal and the DTMF tones will be assigned correctly. Please also note that the IDs are already
preconfigured (901-910); for example, if you want to configure the external unit 910, please use
the external unit 10 and don’t just rename the external unit 1 from 901 to 910. The same applies
for the internal units, which are pre-configured from 101 to 120.
Once the external units are configured at wish, the changes can be saved by clicking on the back button on
top of the page, as already mentioned before.
